Updated Oct 3/24
RED Komodo Power Accessories
REDVOLT BP - $225 - in stock
REDVOLT BP’s provide longer run times (6300mAh) in a familiar compact form factor for your RED KOMODO. Batteries fully communicate with the KOMODO, allowing for charging from the camera and provides time remaining information. REDVOLT BP batteries can be attached directly to one or both BP slots on the rear of the KOMODO & can be hot-swapped. Approximate run time - 2 hours.
NOTE: REDVOLT BP is not compatible with DSMC, DSMC2 or RED RANGER camera systems.
Core RED Komodo V-Mount Plate CXV-KOMU - $269 - special order
The CXV-KOMU is a BP to v-mount plate direct mount specifically designed for the RED Komodo camera, allowing use of 14.4V V-Mount batteries and leaving the camera’s DC input available for AC power and battery hot swap. When used with “smart” batteries that pass SMBUS data like Core SWX batteries, the camera will read battery percentage and runtime, providing accurate remaining battery capacity info. It’s equipped with 3 DC output ports: P-Tap, USB, and 2pin Lemo. The plate also has a reinforced V-Mount locking mechanism, making it the most robust V-Mount plate on the market.
Tilta V-Mount Advanced Power Distribution Module For Komodo - $510 - special order
(TA-T08-APV2-B) Black. This Module adapts the RED Komodo's dual Canon BP battery slots to a V-Mount. When using V-Mount batteries, this module will fully communicate with your camera body, allowing you to see your remaining battery life as a percentage on the RED Komodo's user interface. These modules will display 100% battery life for any voltage over 16V and will hit 0% at 12V which will align perfectly for most batteries. For batteries that can go below 12V, the module will stop powering the camera while there is still some life left in the battery, however, since most don't go much lower than 12V, the difference in duration should be negligible. This Module features an integrated Komodo EXT Cable that connects to the camera body to provide full communication for expanded functions like Run Stop and Timecode via additional ports. One of these ports being a 3 Pin Fischer R/S port allows you to trigger Run Stop and power a Nucleus M with a single cable via the optional 3 Pin Fischer Run Stop Cable.
The Module features the following ports:
• 14.8V P-Tap Port
• 14.8V 2-Pin LEMO Port
• 3 Pin Fischer R/S Port
• Timecode Port
• Red CTRL Port
• Genlock Port
• 5V USB Port
Wooden Camera Battery Slide - Reg $620 Sale $449 - limited stock
(280300)
Battery Slide Pro V-Mount (RED® KOMODO) attaches to the camera-left, BP-9 battery slot and powers the camera using a right angle LEMO compatible connector. Thumbscrew can be loosened to tilt and slide the plate as needed.
Three D-Taps on the plate provide battery voltage for accessories and power is monitored for over-current. If more than 5.8A are used by accessories, a digital fuse will trip and the red LED will illuminate but the camera will remain powered. Reset button can be pressed once to restart accessory power.
DC Input on camera-right side can be used for hot-swapping between block battery and on-board battery. While the AC adapter that comes with the KOMODO can be used, please note that it may not be powerful enough to sustain the camera and accessory draw.
Specifications:
Weight: 264 g (0.59 lbs)
Dimensions: 127 x 114.3 x 44.45 mm (5 x 4.5 x 1.75 in)
CineCrew 2 Pin LEMO Right Angle to SafeTap for RED Komodo 12" - $179 - in stock
CineCrew 2 Pin LEMO Right Angle to SafeTap for RED Komodo 18" - $189 - more in soon
CineCrew 2 Pin LEMO Right Angle to SafeTap for RED Komodo 36" - $199 - more in soon
CineCrew 2 Pin LEMO Right Angle to D-Tap for RED Komodo 18" - $129 - special order - 2-3 wks
CineCrew 2 Pin LEMO Right Angle to D-Tap for RED Komodo 36" - $139 - special order - 2-3 wks
CineCrew 2 Pin LEMO Straight to D-Tap for RED Komodo 18" - $119 - special order
Please note: This cable is only compatible with RED Komodo. It uses a 2-Key locator connector. DO NOT use with Teradek or other 2 Pin capable devices.
SafeTap Cables for RED DSMC2/DSMC3/Komodo-X/All V-Raptors
The RED PTap-to-Power Cable allows you to power your KOMODO camera from a P-Tap power source. Length measured from end-to-end of cable including connectors.
RED P-Tap to Power Cable for Komodo
3' (790-0675) - $140 - in stock
6'
(790-0676 ) - $159 - in stock
Find Komodo Accessories here